Maintenance And Service; Maintenance: Frequency And Tasks; Maintenance Tasks - Homeowner - Majestic QUARTZPLA36IN Owner's Manual

4 4

Maintenance and Service

IMPORTANT! Any safety screen, decorative barrier front
or guard removed for servicing must be replaced prior to
operating the fireplace.
When properly maintained, your fireplace will give you
many years of trouble-free service. Contact your dealer
to answer questions regarding proper operation, trouble-
shooting and service for your appliance. Visit www.ma-
jesticproducts.com to locate a dealer. We recommend
annual service by a qualified service technician.
A. Maintenance: Frequency and Tasks
Task Frequency
Glass Cleaning Seasonally
Decorative Barrier
Annually
Fronts
Remote Control Seasonally
Venting and
Seasonally
Termination Cap
Gasket Seal and Annually
Glass Assembly
Inspection
Log Inspection Annually
Firebox Inspection Annually
Control Annually
Compartment and
Firebox Top
Pilot and Burner Annually
Ignition and
Operation
LED Replacement As needed
Electrical Service
As needed
and Repair
B. Maintenance Tasks - Homeowner
Installation and repair should be done by a qualified service
technician only. The appliance should be inspected before
use and at least annually by a professional service person.
The following tasks may be performed annually by the
homeowner. If you are uncomfortable performing any of
the listed tasks, please call your dealer for a service ap-
pointment.
More frequent cleaning may be required due to excessive
lint from carpeting, bedding material, etc. It is imperative
that control compartments, burners and circulating air
passageways of the appliance be kept clean. Any safety
screen, guard, or barrier removed for servicing the appli-
ance must be replaced prior to operating the appliance.
CAUTION! Risk of Burns! The fireplace shall be turned
off and cooled before servicing.
Majestic • QUARTZPLA36IN / QUARTZPLA36IL Owner's Manual • 2643-981 Rev. B • 7/22
14
To be completed by
Homeowner
Qualified Service
Technician
Glass Cleaning
Frequency: Seasonally
By: Homeowner
Tools Needed: Protective gloves, gas fireplace glass
cleaner, drop cloth and a stable work surface.
CAUTION! Handle fixed glass assembly with care.
Glass is breakable.
• Avoid striking, scratching or slamming glass
• DO NOT use abrasive cleaners
• DO NOT clean glass while it is hot
• Prepare a work area large enough to accommodate fixed
glass assembly and decorative barrier front by placing a
drop cloth on a flat, stable surface.
Note: Fixed glass assembly and gasketing may have res-
idue that can stain carpeting or floor surfaces.
• Remove decorative barrier front from fireplace and set
aside on work surface.
WARNING! Risk of Asphyxiation! Handle fixed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fireplace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Remove Fixed Glass Assembly
• Pull the four glass assembly latches out of the groove
on the glass frame. Remove glass assembly from the
appliance. See Figure 4.1.
• Clean glass with a non-abrasive, non-ammonia based,
commercially available gas fireplace glass cleaner
- Light deposits: Use a soft cloth with soap and water
- Heavy deposits: Use commercial fireplace glass
cleaner (consult with your dealer)
• Carefully set fixed glass assembly in place on fireplace.
Hold glass in place with one hand and secure all glass
latches with the other hand.
• Inspect and operate all glass latches to ensure they
move freely and no obstructions are present.
Replace Fixed Glass Assembly
• Replace the glass door on the appliance. Pull out and
latch the four glass assembly latches into the groove on
the glass frame.
• Reinstall decorative barrier front.
.