Table of Contents
Advertisement
SM-RAZOR-F Instruction Manual
Step 2: Mount Arms to TV
A. Determine the diameter of the screw
(parts C through P & U) your TV requires
by carefully hand-threading one into the
TV mounting holes. Stop immediately if
there is any resistance.
B. Use spacers under the mounting arms
on TVs with curved backs or recessed
mounting screw inserts. The screw will
thread through the washers (Q or R),
arms, spacers (S or T), and into the TV.
C. Ensure the arms are installed flat side
to TV and square to each other after all
screws have been installed (Figure 4).
Mount the arms to the TV as high as
possible for easier access to the post-
install leveling screws.
D. Slide the clip up or down to lengthen or
shorten the release string on the arms.
Adjust the height of the Arm release to be
above the bottom of the TV. (Figure 5).
Display Leveling Adjustment
After mounting, the display may not be
hanging perfectly level. The set screw
at the top of each mounting hook allows
either side to be adjusted using a Phillips
screwdriver (Figure 6).
Place a level on one side of the display
as the adjustment is made. Turn the
screw clockwise to raise a side, or
counterclockwise to lower a side, until
the display is level.
WARNING: Turning the leveling adjustment screws
too far clockwise to raise the display height could
lock the display brackets to the wall plate. This
could cause damage to the display or the mount
when trying to disconnect the display brackets from
the wall plate.
pg.6
Figure 4
Figure 5
Lengthen
Top of Arm
Figure 6
Leveling
Adjustment Screws
www.snapav.com Support: 866.838.5052
Shorten
Advertisement
Table of Contents
