Strong SM-RAZOR-F-M Installation Manual page 5

A. Pre-drill holes into concrete using 5/16" drill bits to a depth of 2 1/2". Insert
concrete Wall Anchors (B) and tap in-with hammer, if necessary (Figures 2
& 3).
B. Insert the four Lag Screws (A) into the Wall Anchors through the Wall Plate and
tighten all bolts.
WARNING: Tighten bolts so that wall plate is firmly attached, but do not over
tighten. Over tightening can damage the bolts, greatly reducing their holding
strength.
Figure 2
Correct
plas ter/
drywall
© 2015 Strong
TM
Incorrect
plaster/
drywall
concrete
Figure 2
Figure 3
Drill holes and
insert anchors.
Place wall arm
assembly plate
concrete
over anchor and
secure with
lag screw.
Tighten all
lag screws.
SM-RAZOR-F Instruction Manual
Concrete
Wall
Wall Arm
Flange Bolt
Figure 4
pg.5