Advertisement
Safety
Safety Alert Symbol
This Safety Alert Symbol (Figure 3) is used both in
this setup instructions and on the machine to identify
important safety messages which must be followed to
avoid accidents
This symbol means: ATTENTION! BECOME
ALERT! YOUR SAFETY IS INVOLVED!
1. Safety alert symbol
The safety alert symbol appears above information
which alerts you to unsafe actions or situations and will
be followed by the word DANGER, WARNING, or
CAUTION.
DANGER: White lettering / Red background. Indicates
an imminently hazardous situation which, if not avoided,
Will result in death or serious injury.
WARNING: Black lettering / Orange background.
Indicates a potentially hazardous situation which, if not
avoided, Could result in death or serious injury.
CAUTION: Black lettering / Yellow background.
Indicates a potentially hazardous situation which, if not
avoided, May result in minor or moderate injury.
This manual uses two other words to highlight
information. Important calls attention to special
mechanical information and Note emphasizes general
information worthy of special attention.
Installing the Hood Assembly and
the Bags
For Lazer Z Units Serial Number
510,000–789,999:
Note: Reference Figure 1 and Figure 2 for the item
numbers called out in the installation instructions.
1. Temporarily remove the ROPS to allow for
installation of the Ultra Vac. Retain the hardware
for reuse.
2. When installing the Ultra Vac onto a liquid-cooled
Lazer Z, the rear bumper plate must be removed.
Remove rear bumper plate. Reattach the lower side
Figure 3
bumper bars to the vertical "HOT" engine guard
shield using two of the original screws, washers and
whizlock nuts removed from the bumper plate.
3. Remove the lower two screws holding the clutch
guard plate ("HOT" engine guard on liquid-cooled
units) to the rear frame of the Lazer Z unit.
4. Install the mount weldment (item 9) loosely to the
rear of the machine using the two bolts and nuts
removed in step 2.
5. Install the frame brackets (item 16) and spacers
(item 17) loosely to the mount weldment (item 9)
as shown. Secure using four 3/8-16 x 1 1/4 inch
screws (item 23), four 3/8 spring disc washers (item
25) and four 3/8-16 inch whizlock nuts (item 24).
Make sure that the raised portion of the spring disc
washer faces the head of the screw (see Figure 4).
6. Install the frame brackets (item 16), and ROPS lower
roll bar tubes loosely to the mounting pads on both
sides of the Lazer frame. Use the hardware supplied
in the parts bag: eight 3/8-16 x 1 1/4 inch screws,
eight 3/8 spring disc washers and eight 3/8-16 inch
whizlock nuts. Make sure that the raised portion of
the spring disc washer faces the head of the screw
(see Figure 5).
6
Figure 4
Advertisement
