Advertisement
plates (item 42) and a front weight (item 41) to be
installed. The front weight is removable and retained
by using hairpins (item 43).
Units Serial Number 439,999 and
Lower:
1. Locate the position of the mounting holes. Clamp
a weight plate to the front of the floor pan (see
Figure 18). The ears on the weight plate should be
towards the bottom (upside down from the actual
mounted position). Align the bottom edge of the
weight plate with the bottom edge of the floor pan
front panel. Center the weight plate side to side.
Mark the position of all four holes using a center
punch.
2. Drill 3/8 inch holes at the points marked.
1. Position ears on weight as
shown.
For Units Serial Number 439,999 and
Lower without a ROPS Installed:
Install the four weight plates behind the front panel
using the 5/16-18 x 1 3/4 inch screws, 5/16 inch
washers and 5/16-18 inch whizlock nuts (items 34, 35,
and 36). The weight plates will only fit with the ears
located near the bend in the floor pan (see Figure 19).
The decal on the outside of the floor pan will still be
visible with the weight plates mounted.
Figure 18
2. Align plates to this edge
to locate and drill holes
(Note the position of ears).
For Units Serial Number 439,999 and
Lower with a ROPS:
1. Install four weight plates behind the front panel
and two weight mounting plates (items 33 and 39)
as shown in Figure 20 using four 5/16-18 x 2 inch
screws, four 5/16 inch flat washers, and four 5/16-18
inch whizlock nuts (items 34, 35, and 36).
2. Hook weight plate assembly (item 40) over the top
of the weight mounting plates and secure with two
hairpins (item 42) as shown in Figure 20.
Note: The removable weight is heavy. Use care
when lifting. Make sure that you can hold the
weight securely before lifting. Use caution when
positioning your hands so that you Do Not set
the weight down on your hands or fingers.
For Units Serial Number
440,000–599,999:
1. Locate the position of the mounting holes by aligning
the template (P/N 103-5865) on the front face of the
floor pan as shown in Figure 21. Clamp the template
in place. Using a center punch, mark the positions
of the holes on the floor pan. Flip the template over
and repeat on the other end of the floor pan face.
14
Figure 19
Figure 20
Advertisement
