Advertisement
Figure 21
1. Align template along these three edges.
2. Drill 3/8 inch holes at the points marked.
3. Install four weight plates behind the front panel
and two weight mounting plates (items 33 and 39)
as shown in Figure 22 using four 5/16-18 x 2 inch
screws, four 5/16 inch flat washers, and four 5/16-18
inch whizlock nuts (items 34, 35, and 36).
Figure 22
4. Hook weight plate assembly (item 40) over the top
of the weight mounting plates and secure with two
hairpins (item 42) as shown in Figure 22.
Note: The removable weight is heavy. Use care
when lifting. Make sure that you can hold the
weight securely before lifting. Use caution when
positioning your hands so that you Do Not set
the weight down on your hands or fingers.
For Lazer Z XS Liquid-Cooled Units
Serial Number 600,000 and Higher:
1. Locate the position of the mounting holes by aligning
the template (P/N 103-5865) on the front face of the
floor pan as shown in Figure 21. Clamp the template
in place. Using a center punch, mark the positions
of the holes on the floor pan. Flip the template over
and repeat on the other end of the floor pan face.
2. Drill 3/8 inch holes at the points marked.
3. Install the four weight plates behind the front panel
and one weight plate on the front using the 5/16-18
x 1 3/4 inch screws, 5/16 inch washers, and 5/16-18
inch whizlock nuts (items 34, 35, and 36). The
weight plates will only fit with the ears located near
the bend in the floor pan (see Figure 19). The decal
on the outside of the floor pan will still be visible
with the weight plates mounted.
Installing the Removable Weights:
Note: The removable weights are heavy. Use care
when lifting them. Make sure that you can hold
them securely before lifting them. Use caution
when positioning your hands so that you Do Not
set them down on your hands or fingers.
1. Assemble the weight brackets (item 31) to the
removable weights (item 11) using the 3/8-16 inch
square head bolts (item 32) and 3/8 inch whizlock
nuts (item 24).
Unit
Lazer Z 52 inch
Units, All
Lazer Z AS 60
inch Units, All
Lazer Z 60 inch
Units-Non Triton
Lazer Z 60 inch
Units-Triton
Lazer Z 66 inch
Units
Lazer Z AS 72
inch Units
Lazer Z 72 inch
Units
Lazer Z XP 60
inch Units
Lazer Z XP 72
inch Units
Lazer Z XS 60
inch Units
Lazer Z XS 66
inch Units
Lazer Z XS 72
inch Units
* 1 1/2 inch bracket is included in Ultra Vac
completion kit 109-1179 or 109-1189.
2. Install the removable weight assemblies over the
caster arms. On all 52 inch units and some 60 inch
units one weight has a wide mounting bracket and
one has a narrow bracket. They will only fit the
machine one way. Weights for all other units are
interchangeable left and right.
3. Install a clevis pin (item 19) and hairpin (item 20) on
each caster weight to retain them.
4. Tighten knob on weight assembly until the weight is
clamped securely to the caster arm.
15
2 inch Bracket
1 1/2 inch
Bracket
1
*
1
1
*
1
1
1
2
2
2
2
2
2
2
2
2
Advertisement
