Table of Contents
Advertisement
8
Adjustments
Figure 16: Adjusting the vertical lift on the spring arm
1
Nm
Nm
1568913, Edition 2019-06, Version 0
8.6
(See Figure 16)
When replacing an end device (e.g. flat screen, medical device, etc.) the
spring arm must be adjusted to the horizontal (0 degree position).
8.6.1 Opening the front, upper cover panel
1
(See Figure 16)
1.
2.
2
3.
8.6.2 Adjusting the vertical lift
(See Figure 16)
1
Tool to be used
Use an Allen key (size 10) and a ring spanner (size 18).
4.
5.
1
To reduce the vertical lift:
•
3
To increase the vertical lift:
•
6.
7.
NOTE – Vertical lift changing
4
5
8.6.3 Closing the front, upper panel
8.
9.
•
•
Adjusting the vertical lift on the spring arm
Follow the general safety instructions prescribed in Chapter 8.1 on
page 27.
Insert a suitable screwdriver into the 2 openings② one after the
other and then disengage the 2 latches ① .
Fold up the front, upper cover③ until it snaps into place.
Loosen and turn back the hexagonal nut M12④ – ISO 4035.
Insert the Allen key into the adjustment screw⑤ .
Turn the Allen key to the left (anti-clockwise) as illustrated in the
Figure.
Turn the Allen key to the right (clockwise) as illustrated in the Figure.
Perform a function test.
Tighten the hexagonal nut M12④ – ISO 4035.
The vertical lift can change progressively during use if the
hexagonal nut M12④ – ISO 4035 has not been properly
tightened:
In this case there is a risk of the spring arm hitting the
ceiling or another pendant system:
• Tighten the hexagonal nut M12④ – ISO 4035 with a
tightening torque of 30Nm.
Fold down the front, upper cover③ such that the 2 latches① snap
into place.
Check that the cover③ is securely in place:
The guides (not illustrated) of the cover③ must sit in the side panels.
The cover③ must sit on the side panels without gaps.
32
en
Advertisement
Table of Contents
