Table of Contents
Advertisement
8
Adjustments
Figure 15: Adjusting the load bearing capacity and closing the
lower, rear cover panel
Nm
Nm
8.5.2 Adjusting the load bearing capacity
(See Figure 15)
Tool to be used
Use an Allen key (size 10) or a ring spanner (size 24).
1
4.
Unscrew the Allen cylinder screw M8 x 16mm③ – DIN 7984.
5.
Insert the Allen key into the adjustment screw④ .
•
Lift the spring arm approx. 10 degrees above the horizontal
(0 degree position) in order to relieve the tension on the adjustment
screw④.
If the spring arm moves down, the load bearing capacity is too low:
•
Turn the Allen key to the left (anti-clockwise) as illustrated in the Fig-
ure.
If the spring arm moves up, the load bearing capacity is too high:
•
Turn the Allen key to the right (clockwise) as illustrated in the Figure.
6.
Perform a function test.
7.
Screw in and tighten the Allen cylinder screw M8 x 16mm③ – DIN
1
7984.
NOTE – Load bearing capacity changing
The load bearing capacity adjustment can change progres-
sively during use if the Allen cylinder screw M8 x 16mm③
– DIN 7984 has not been properly tightened:
If this is the case, the spring arm no longer remains stable
2
in its adjusted position:
• Tighten the Allen cylinder screw M8 x 16mm③ –
DIN 7984 with a tightening torque of 12Nm.
8.5.3 Closing the lower, rear cover panel
(See Figure 15)
3
8.
Fold up the lower, rear cover panel② until the 2 latches① snap into
place.
4
9.
Check that the cover② is securely in place:
•
The guides (not illustrated in the Figure) of the cover② must sit in the
side panels.
•
The cover② must sit on the side panels without gaps.
31
1568913, Edition 2019-06, Version 0
en
Advertisement
Table of Contents
