Table of Contents
Advertisement
Quick Links
USER GUIDE
When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance
specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Heating.
For the very latest copy of literature for specification and maintenance practices visit our website idealheating.com
where you can download the relevant information in PDF format.
October 2022
UIN 228297 A05
LOGIC SYSTEM
S15 S18 S24 S30
2
Advertisement
Table of Contents
Related Manuals for Ideal Heating LOGIC SYSTEM 2 S15
Summary of Contents for Ideal Heating LOGIC SYSTEM 2 S15
- Page 1 When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Heating.
-
Page 2: Table Of Contents
Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal Heating is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency. -
Page 3: Introduction
INTRODUCTION IMPORTANT NOTES • This appliance must not be operated without the casing The Logic System S is a system boiler, featuring full sequence correctly fitted and forming an adequate seal. automatic spark ignition and fan assisted combustion. • If the boiler is installed in a compartment then the Due to the high efficiency of the boiler, condensate is produced compartment MUST NOT be used for storage purposes. -
Page 4: Condensate Drain
OPERATION MODES BOILER FROST PROTECTION Winter/Summer Conditions – (Domestic Hot Water required, The boiler is fitted with frost protection that operates in all Central Heating may be required) modes, provided the power supply to the boiler is always turned on. If the water in the boiler falls below 5ºC, the frost If OFF is shown at the bottom of the screen then press the protection will activate and run the boiler to avoid freezing. -
Page 5: General Information
LOSS OF SYSTEM WATER PRESSURE Preventative solutions During cold weather, set the central heating temperature knob (A) to maximum (must return to original setting once cold spell The gauge (G) indicates the central heating system pressure. is over). If the pressure is seen to fall below the original installation Place the heating on continuous and turn the room thermostat pressure of 1-2 bar over a period of time then a water leak down to 15ºC overnight or when unoccupied. -
Page 6: Troubleshooting
TROUBLESHOOTING NO HOT WATER NO CENTRAL HEATING NO HOT WATER AND NO CENTRAL HEATING Check the mains power is Check that the mains power is Check that the mains power is switched on and that ON is turned on and that ON is shown turned on and that ON is shown shown at the bottom of the at the bottom of the screen (if not... -
Page 7: Fault Codes
FAULT CODES DESCRIPTION ACTION DISPLAY CODE ON BOILER Low Water Pressure Check system water pressure is between 1 & 1.5bar on the system pressure gauge. To F 01 re-pressurise the system see Section 3. If the boiler still fails to operate then please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the warranty period. - Page 8 At Ideal Heating we take our environmental impact seriously, therefore when installing any Ideal Heating product please make sure to dispose of any previous appliance in an environmentally conscious manner. Households can contact their local authority to find out how.