Tripp Lite SmartOnline S3MX Owner's Manual page 30

4. Control Panel and LCD Operations
Table 4.6: Setup-General Setting List
Setting Item Sub Item
Model Name --
Language --
Adjust Time
System Installed Date
TIME
System Last Maintain Date
Battery Installed Date
Battery Last Maintain Date
Baud Rate --
Audible Alarm --
Factory Reset --
EEPROM Reset --
EPO Function --
Password --
Save Setting --
Startup Screen --
Explanation
Set UPS Name (xxxxxxxxxx).
The max. length is 10 characters.
English only
Set current date and time.
(yyyy / mm / dd hour : min : sec)
MUST be set after UPS installation
Set system installed date
(yyyy / mm / dd)
2018/1/1 (Default)
MUST be set after UPS installation
Set system latest maintenance date
(yyyy / mm / dd)
MUST be set after UPS installation
Maintainer/Administrator Only
Set battery installed date
(yyyy / mm / dd)
MUST be set after UPS installation
Set battery latest maintenance date
(yyyy / mm / dd)
MUST be set after UPS installation
Set SNMP Port (COM Port0) Baud Rate
• 2400 (Default)
• 4800
• 9600
Set RS-232 Port (COM Port1) Baud Rate
• 2400 (Default)
• 4800
• 9600
Set Audible Alarm
• Disable
• Enable (Default)
Restore to factory default setting
Refer to Table 4.7
Restore EEPROM to default setting
Refer to Table 4.7
Set EPO active status
• Normal Close Active (Default)
• Normal Open Active
Set New Password.
0000 (Default)
Save all settings to EEPROM.
Use this feature to save the changed setting(s). Must be performed when
any changes are made to the settings.
Set up initial screen. (xxxxxxxxxxxx).
The max. length is 12 characters.
30