Table of Contents
Advertisement
Replacing an External Desktop Switch
Never install the desktop switch in a vertical position.
1. Remove the power cord from the failed switch module.
2. Remove the data cables from the failed switch and label them for your
reference.
3. Remove the dust cover from the replacement switch, if in place, and save
for future use.
Make sure the rubber feet are installed.
4. Position the switch on the desktop so it is within reach of the chassis to
which it will be connected.
Allow at least two inches of space on each side of the switch and do not
place anything on top of the module. This ensures adequate ventilation for
the switch.
5. Power up the replacement switch.
Check the LEDs to ensure the switch is operational.
6. Re-attach the data cables to the replacement switch module.
You are done replacing the desktop switch.
TurboStack Chassis and Backplanes
Warning
33
Advertisement
Table of Contents
