Chassis Installation
4. Remove the four screws and rubber feet from the bottom of all modules as
shown in Part A of Figure 11.
5. Re-install the same four screws you removed in Step 4 without the rubber
feet, as shown in Part B of Figure 11.
After removing the rubber feet, you must replace the screws. Otherwise,
the unit will expand and not fit in the chassis. Save the rubber feet so they
may be used again in a standalone configuration at a later date.
6. Remove the dust covers from the backs of all newly-shipped ATI modules,
as shown in Figure 12.
Interrepeater bus
port connector
14
A
Figure 11: Removing the Rubber Feet
T E R
P E A
R R E
IN T E
T T E
S S E
E C A
W A R
F IR M
Hub with dust cover installed
F IR M
Figure 12: Removing the Dust Cover
B
Note
U S
S TA T
T
FA UL
B U S
TE R
M AS
ER
PO W
B U S
T E R
P E A
R R E
IN T E
T T E
S S E
E C A
W A R
Dust cover
U S
S TA T
FA UL
T
TE R
M AS
PO W
ER