The Chassis Products - Allied Telesis TurboStack AT-TS06F Series Installation Manual

Preface

The Chassis Products

This manual describes the TurboStack chassis with power. Chassis products
are available in the following size options:
The standard four- and eight-slot chassis with standard backplanes
allow you to stack up to four and eight TurboStack hubs, respectively.
The seven-slot chassis with segmented backplanes allow you to stack
up to six TurboStack hubs and either one AT-TS90TR or one
AT-TS95TR switch module. Whether you install the AT-TS90TR or
the AT-TS95TR, each switch module occupies two times the chassis
space of a TurboStack hub.
The four- and eight-slot chassis with segmented backplanes are
designed to hold all TurboStack hubs and can be used with an external
switch (such as the AT-TS90TR, AT-TS95TR, AT-4016TR, or the
AT-4016F/XX).
Chassis models from ATI are shipped with factory-installed labels that say
"Standard" or "Segmented" on the upper right corner of the front of the
chassis.
For a complete list of chassis options available from ATI, contact your ATI
sales representative. A summary of these chassis options is given in Table 1.
Standard Non-segmented
(Use with hubs)
Segmented
(Use with hubs and one switch
installed in the chassis)
Segmented
(Use with hubs and an external switch)
If customers choose to install segmented backplanes on their existing
chassis models, each new replacement backplane will be shipped with a
self-adhesive "segmented" label. Customers attach this label on the upper
right corner of the front of the chassis to identify the configuration.
xvi
Table 1: Chassis Options
Chassis Desktop
4-slot
8-slot
7-slot
4-slot
8-slot
Note
Rackmount
4-slot
8-slot
7-slot
4-slot
8-slot