Husqvarna MADSAW 525iDEPS Operator's Manual page 9

Note:This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This product meets the applicable Innovation,
Science and Economic Development Canada
technical specifications.
Le présent produit est conforme
aux spécifications techniques applicables
d'Innovation, Sciences et Développement
économique Canada.
Le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement
économique Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux
conditions suivantes:
• l'appareil ne doit pas produire de
brouillage, et
• l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le
fonctionnement.
Suppliers Declaration of Conformity for
Husqvarna525iDEPS Powerhead
Responsible Party
Husqvarna Professional Product, Inc.
9335 Harris Corners Parkway
1824 - 003 - 28.06.2022
Charlotte, NC 28269
United States
Telephone: +1 704 597 5000
E-mail: http://www.husqvarna.com/us/
support/e-mail/
Personal protective equipment
WARNING:
instructions that follow before you
use the product.
• Always use approved personal protective
equipment when you use the product.
Personal protective equipment cannot fully
prevent injury but it decreases the degree
of injury if an accident does occur. Let your
dealer help you select the right equipment.
• Use a protective helmet where there is a
risk of falling objects.
• Use approved hearing protection that
provides adequate noise reduction. Long-
term exposure to noise can result in
permanent hearing impairment.
• Use approved eye protection. If you use
a visor, you must also use approved
protective goggles. Approved protective
goggles must comply with the ANSI Z87.1
standard in the USA or EN 166 in EU
countries.
• Use gloves when necessary, for example
when you attach, examine or clean the
cutting equipment.
Read the warning
9