Husqvarna MADSAW 525iDEPS Operator's Manual page 17

4. When all LEDs on the battery come on, the
battery is fully charged.
5. To disconnect the battery charger from the
mains socket, pull the plug. Do not pull the
cable.
6. Remove the battery from the battery
charger.
Note:
Refer to the battery and battery
charger manuals for more information.
To check before starting
1. Inspect the working area. Remove any
objects that could be thrown out.
2. Check the cutting attachment. Never use
blunt, cracked or damaged equipment
3. Check that the machine is in perfect
working order.
4. Check that all nuts and screws are tight.
5. Make sure the chain is adequately
To adjust the chain
lubricated. See,
lubrication on page 26 .
6. Make sure that the cutting attachment
always stops when you release the throttle/
power trigger.
7. Only use the product for the purpose it was
intended for.
8. Make sure the handle and safety features
are in order. Never use a machine that has
any parts missing or has been modified in
relation to the specification.
1824 - 003 - 28.06.2022
To start the product
1. Push and hold the start button until the
green LED comes on.
2. Use the power trigger to control the speed.
To limit the maximum speed with the
mode button
The product has a mode button. Withe
the mode button the operator can limit the
maximum speed. The mode button has 3
speed levels. A lower level increases the time
of operation for the product. The mode button
has 3 speed levels. A lower level increases
the time of operation for the product. Use level
1 and level 2 if the operation does not require
full speed/full power. If the operation condition
requires full speed/full power, use level 3. Do
not use a higher level than necessary for the
operation.
1. Push the mode button to set a limit to the
maximum speed. The white LEDs comes
on to show that the function is on.
2. Push the Mode button again to choose the
next speed level.
17