DIR-X1530 AX1500 Wi-Fi 6 Gigabit Router
User Manual
Creating PPPoE IPv6 or PPPoE Dual Stack WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 80. The page for creating a new PPPoE IPv6 connection. The General Settings section.
Parameter
Interface
Connection name
Enable connection
NAT
Ping
RIP
General Settings
A physical or virtual WAN interface to which the new connection
will be assigned.
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
For the PPPoE Dual Stack type only.
If the switch is moved to the right, the network address translation
function for IPv4 is enabled. Do not disable the function unless your
ISP requires this.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
For the PPPoE Dual Stack type only.
Move the switch to the right to allow using RIP for this connection.
Page 94 of 254
Configuring via Web-based Interface
Description