D-Link DIR-X1530 User Manual page 131

DIR-X1530 AX1500 Wi-Fi 6 Gigabit Router
User Manual
You can specify the following parameters:
Parameter
Enable
Name
IP address
Mask
Interface
Remote IP
MTU
Allow traffic GRE →
LAN
Remote LAN IP address The IP address of the remote local subnet.
Remote LAN mask
Remote GRE interface
IP address
After configuring all needed settings, click the APPLY button.
To edit the parameters of an existing tunnel, in the Tunnels section, select the relevant tunnel in the
table. On the opened page, change the needed parameters and click the APPLY button.
To remove an existing tunnel, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
Tunnel settings
Move the switch to the right to enable the GRE tunnel.
Move the switch to the left to disable the GRE tunnel.
A name of the tunnel for easier identification. You can specify any
name.
The IP address of the GRE tunnel interface.
The mask of the subnet.
From the drop-down list, select a WAN connection through which
the tunnel will pass. Select the Default gateway value to use the
default WAN connection.
Enter the public IP address of the remote subnet VPN gateway.
The maximum size of units transmitted from the remote host to the
router.
Move the switch to the right to allow GRE tunnel users access
devices in the remote local subnet.
Static route settings
The mask of the remote local subnet.
The IP address of the GRE tunnel interface in the remote subnet.
).
Page 131 of 254
Configuring via Web-based Interface
Description