Table of Contents
Advertisement
5.4.7 Unblocking the collector channel
If the collector channel gets blocked (due to accumulated grass cuttings filling up the
grass-catcher or an excessively high speed with relation to the quantity of grass cuttings),
you need to:
1. stop forward movement immediately, disengage the blade and stop the engine;
2. remove the grass-catcher;
3. remove the accumulated cuttings, reaching them from the exit of the collector channel.
5.4.8 End of mowing
When you have finished mowing, disengage the blade, lower the engine speed and ride
the machine with the cutting deck in the highest position.
5.4.9 End of work
Once you have finished mowing, stop the machine and engage the parking brake.
1. shift the accelerator lever to «OFF».
«OFF» position before leaving the machine unattended
5.4.10 cleaning the machine
After each mowing, clean the outside of the machine, empty the grass-catcher and shake
it to remove residual grass and earth.
containers full of cut grass inside a room.
Clean the plastic parts of the body with a damp sponge using water and detergent, taking
care not to wet the engine, the electrical parts or the electronic card located under the
dashboard.
body and engine!
upper part of the cutting deck in order to keep maximum machine efficiency and
safety levels.
This job must only be performed with the engine Turned off.
Always make sure that the accelerator level is in the
Always empty the grass-catcher and do not leave
Never use hose-nozzles or harsh detergents for cleaning the
Do not let debris and dry remains of grass accumulate in
23
!
Advertisement
Table of Contents
