Table of Contents
Advertisement
For storage and transport purposes, some components of the machine are not installed in
the factory and have to be assembled after unpacking. Follow the instructions below.
starting the engine, fill with oil and fuel following the instructions given in the engine
manual.
on a flat and stable surface, with enough space for machine handling and its
packaging, always making use of suitable equipment.
3.1 UNPACKING
When unpacking the machine, take care to gather all the individual parts, fittings and
documentation.
machine down from the pallet, take it to the maximum height and be very careful.
The supply includes:
– bolts and screws, necessary for completing the assembly;
– a syringe for draining the engine oil. (on request)
Disposal of the packaging should be done in accordance with the local
regulations in force.
3.2 FITTING THE STEERING WHEEL
3
The machine is supplied without engine oil or fuel. Before
Unpacking and completing the assembly should be done
To avoid damaging the cutting deck when getting the
1
Put the machine on a flat surface and straighten up the front
wheels.
1. fit the steering wheel（1）onto the protruding shaft (2)
and fasten it by impacting the included pin (3) into the hole (4),
4
2
09
Advertisement
Table of Contents
