Connecting to the HP 16505A Prototype
Analyzer
To use the HP E3491A Pentium Probe you need to:
•
Install the HP E3491A software (Run Control Tool) in the
HP 16505A Prototype Analyzer
•
Connect the HP E3491A Pentium Probe to a power source
•
Connect the HP E3491A Pentium Probe to the HP 16505A via a
LAN or direct connection
•
Connect the HP E3491A Pentium Probe to the target system
(described in the next chapter)
Equipment supplied
The following equipment is supplied with the HP E3491A Pentium Probe:
•
A 20-conductor cable assembly (HP part number E3491-61601)
•
A 30-conductor cable assembly (HP part number E3491-61602)
•
An adapter board (HP part number E3491-66503)
•
A 2-conductor cable assembly with SMT Grabbers (HP part number
64762-61602)
•
A self-test connector (HP part number E3490-61604)
•
A 7 ft. 10Base-T point-to-point network cable (HP part number
5061-7342)
4