Specifications And Characteristics Processor Compatibility; Electrical Specifications - HP E3491A Installation And Service Manual

Specifications and Characteristics
Processor Compatibility
Processor Compatibility
The HP E3491A Pentium Probe supports the Pentium microprocessors at
iCOMP INDEX 735/90 and 815/100.

Electrical Specifications

BNC, labeled TRIGGER OUT
Output Drive Logic high level with 50-ohm load >= 2.0 V. Logic low
level with 50-ohm load <= 0.4 V. Output function is selectable by the HP
16505A Prototype Analyzer. Refer to Online Help for additional
information.
BNC, labeled BREAK IN
Input Edge-triggered TTL level input (active high), 20 pf, with 2K ohms
to ground in parallel. Maximum input: 5 V above V 5 V below ground.
CC;
Input function is selectable by the HP 16505A Prototype Analyzer.
Refer to Online Help for additional information.
Communications
Serial Port 9-pin female type "D" subminiature connector. RS-232 DCE
to 115.2 kbaud.
10BASE-T LAN Port RJ-45 connector. IEEE 802.3 10BASE-T
(StarLAN).
10BASE 2 LAN Port 50-ohm BNC connector. IEEE 802.3 10BASE2
(ThinLAN). When using this connector, the HP E3491A Pentium Probe
provides the functional equivalent of a Medium Attachment Unit (MAU)
for ThinLAN.
Power Supply
Input 100-240 V, 9.75 A, 50/60 Hz, IEC 320 connector.
Output 5 V, 1.0 A
Accessory Output 100-240 V, 9.50 A, 50/60 Hz
34