HP E3491A Installation And Service Manual page 60

Solving Problems
To execute the built-in performance verification test
The tests available through this command can be displayed as follows:
R>pv -l
Tests Available in Performance Verification;
Test # 1: Powerup PV Results
Test # 2: LAN 10Base2 Feedback Test
Test # 3: LAN 10BaseT Feedback Test
Test # 4: Break In and Trigger Out BNC Feedback Test
Test # 5: Target Probe Feedback Test
Test # 6: Boundary Scan Master Test
R>
On a good system, when the E3490-61604 feedback connector is plugged into
the 20 pin target connector, the RESET LED will light and the BKG and
USER LEDs will be out.
The results on a good system are as follows:
R>pv 1
Testing: HPE3499A Series Emulation System
Test # 1: Powerup PV Results
Test # 2: LAN 10Base2 Feedback Test
Test # 3: LAN 10BaseT Feedback Test
Test # 4: Break In and Trigger Out BNC Feedback Test
Test # 5: Target Probe Feedback Test
Test # 6: Boundary Scan Master Test
PASSED Number of tests: 1
Copyright (c) Hewlett-Packard Co. 1987
All Rights Reserved.
written permission is prohibited, except as allowed under copyright laws.
HPE3499A Series Emulation System
Version: A.05.00 19Jan95 15:53 Proto
Location: Generics
HPE3491A Pentium(tm) Processor Probe Emulator
Version: A.01.00 05Jan95 13:07 Proto
R>
There are some things you can do if a failure is found on one of these tests.
Details of Failure can be obtained through using a verbose level of 2 or more.
52
Number of failures: 0
Reproduction, adaptation, or translation without prior
passed!
passed!
passed!
passed!
passed!
passed!