Table of Contents
Advertisement
R>? pv
pv - Execute the system performance verification diagnostics.
USAGE: pv <-l> <-t*|x[-y]> <-f> <-vverbose_level> <repeat_count>
pv
pv <-l>
pv <-t*|x[-y]>
pv <-f>
pv <-vverbose>
pv <repeat_count> - execute diagnostics (repeat_count> number of times.
SETUP:
10BASE2 FEEDBACK TEST:
Disconnect 10Base2 Connector From the Network
Terminate With Two 50 Ohm Terminators on a TEE
10BASET FEEDBACK TEST:
Connect 10BaseT Connector To Active Port
Examples:
To execute both tests one time:
pv 1
To execute test 2 with maximum debug output repeatedly until a ^C is
entered:
pv -t2 -v9 0
To execute tests 3, 4, and 5 only for 2 cycles:
pv -t3-5 2
To execute the built-in performance verification test
- display pv warning message
- list pv test#s and descriptions only (do not execute)
- select pv test number x or
* selects all emulation tests
- for factory use only
- set verbose level;
repeat_count of 0 repeats until keyboard break
tests x thru y only
valid levels: 1-9.
Solving Problems
51
Advertisement
Table of Contents
