HP E3491A Installation And Service Manual page 27

The lan command parameters are:
The IP address which you obtained from your network administrator.
-i <internet>
The gateway address. Setting the gateway address allows access outside
-g <gateway>
your local network or subnet.
This changes the base TCP service port number.
-p <port>
The prototype analyzer uses the TCP service port numbers 6470 and 6471. If
these numbers are somehow changed in the Pentium probe, they must be
changed back to 6470 and 6471. To change these numbers, you could
modify the line:
hp64700 6470/tcp
Disconnect the power cord from the HP E3491A Pentium Probe, and
6
connect the the HP E3491A Pentium Probe to your network.
This connection can be made by using either the 10BASE-T connector or the
10BASE2 (BNC) connector on the HP E3491A Pentium Probe. Do not use
both connectors at the same time.
Set the configuration switches to indicate the type of connection that
7
is to be made.
Switch S1 must be set to OPEN, indicating that a LAN connection is being
made.
Switch S5 should be 1 if you are connecting to the BNC connector:
Switch S5 should be 0 if you are connecting to the 10BASE-T connector:
Set all other switches to CLOSED.
Connect the power cord to the HP E3491A Pentium Probe.
8
Verify your HP E3491A Pentium Probe is now active and on the
9
network. See "To verify LAN communications" on page 17.
To configure LAN parameters using the built-in terminal interface
Setting Up a Serial Connection
19