Creating Or Installing Clone Files - Toshiba e-STUDIO2000AC Operator's Manual

6.User Functions
 Creating or installing clone files
You can create clone files of the setting data and user data by using the cloning function. These files can also be
installed in other equipment units. This function is convenient when you want to apply the same settings to multiple
equipment units.
 P.44 "Installing the clone data"
 P.46 "Creating clone files"
 The clone files are compatible with other equipment units. For details about the available models, contact your
service representative.
 When an end-user (either an individual or an entity) intends to clone data (font, ICC profile, or any data
downloaded or added by the end-user) stored in TTEC products (copier, MFP), the end-user shall investigate,
review and confirm terms of use for such data and intellectual property rights thereof. The end-user shall perform
such cloning at your own risk and responsibility.
TTEC AND ITS AFFILIATES HEREBY DISCLAIM ANY WARRANTY OF ANY KIND, WHETHER EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO, THE WARRANTIES OF QUALITY AND PERFORMANCE OF TTEC PRODUCTS,
FITNESS FOR A PARTICULAR PURPOSE, NON-INFRINGEMENT OF THIRD PARTIES INTELLECTUAL PROPERTY RIGHTS,
IN THE USE OF CLONING BY THE END-USER.
IN NO EVENT WILL TTEC BE LIABLE TO THE END-USER NOR ANY THIRD PARTY FOR ANY DAMAGES, WHETHER IN
CONTRACT, TORT, OR OTHERWISE, INCLUDING WITHOUT LIMITATION ANY LOST PROFITS, LOST DATA OR OTHER
INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF CLONING BY THE END-USER, TO THE
MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW.
When installing the clone data, store the corresponding files in the root directory of your USB storage device in
advance.
For details of the cloning function, contact your service representative.
 Installing the clone data
1
On the Cloning screen, press [Install Clone Data].
2
Connect your USB storage device in which the clone files are stored to the USB port on the
equipment, and press [OK].
For the location of the USB port on the equipment, refer to the Quick Start Guide "Chapter 1: PREPARATIONS".
44 Admin