Raw Tcp/Lpr Printing - Toshiba e-STUDIO2000AC Operator's Manual

8.Install Disc
 Raw TCP/LPR printing
Configure the Raw TCP/LPR port as described in the following procedure.
Confirm the following before starting the configuration:
 This equipment is connected to the network and turned on.
 The TCP/IP setting is correct on this equipment and your computer.
 Searching your TOSHIBA MFP automatically
This equipment is automatically discovered over the network. Then you can install the printer driver so as to configure
the Raw TCP/LPR port.
If this equipment is not discovered over the network after the installation is started, a dialog box indicating this
appears. Follow the procedure below to continue the configuration.
 To search this equipment over the network again, click [Retry].
 Click [SNMP Settings] and confirm whether the SNMP settings specified in the [SNMP Settings] dialog box are
correct.
When you confirm or change the SNMP settings in order to find your TOSHIBA MFP, see the following section.
 P.104 "Confirm or change the SNMP settings"
 When you set the conditions to search the MFPs on the network in the [Manual Selection] dialog box, see the
following section.
 P.105 "Narrowing Down Search Conditions"
 If your TOSHIBA MFP is not found, refer to the following page:
 P.101 "If your TOSHIBA MFP is not found"
 If you know the IP address of this equipment, you can specify a printer port with the direct entry from the keyboard.
In step 6, enter a network path shown below in [Printer port].
\\IP_<IP address> or \\<IP address>
6
A list for the discovered printers is displayed. Then select this equipment on the list and then
click [Install].
Searching may take a while depending on the Windows OS or network environment.
Installing the printer drivers by using the individual installers 99