Power And Scan Indicator Light; Getting Started - Pandigital PANSCN10 User Manual

P ow e r and S c an In dicator L igh t
The indicator light patterns and the functions they indicate are as follows:
 Off = scanner is off or scanner is on and ready for use
 Orange briefly = powering on (wait until the initialization process completes before using
the scanner)
 Green steadily on = scanning in progress in 300dpi mode or battery is charging (stays on
until fully charged). In Power Off mode, green LED means the battery is charging.
 Orange steadily on = scanning in progress in 900dpi mode
 Green or Orange flashing = processing scanned image
 Red flashing = no SD card (insert SD card), SD card full, card error, no scan performed
after initiating wand scan mode, or low battery (replace battery).
 Green flashes = when scanner is inserted into the feeder dock, 2 green flashes indicate
the switch from battery power to feeder dock power.
Getting S t art ed
1. Remove the scanner from the feeder dock:
a) Press the latch.
b) Lift the end of the scanner up to clear the latch.
c) Pull the scanner out of the feeder dock to
disengage from the connector.
2. Remove the foam pad from end of scanner and taped cushion inside feeder dock.
3. Insert the Lithium Ion NP-45 rechargeable batterypack:
a) Remove the cover.
b) Insert batterypack.
c) Replace the cover.
4. To charge the battery, insert scanner in the feeder
dock and the power adapter plug into the wall, and
power connector on the end of the feeder dock.
 Charge for at least 2 hours (until green LED
goes off) before using the scanner.
5. Insert a SD card.
10
(a) (b)
b
c
a
(c)