Creating Dynamic Ipv6 Or Static Ipv6 Wan Connection - D-Link DIR-842 User Manual
Ac1200 wave 2 mu-mimo wi-fi gigabit router
Hide thumbs
Also See for DIR-842:
- User manual (233 pages) ,
- Quick installation manual (83 pages) ,
- Quick install manual (13 pages)
Table of Contents
Advertisement
DIR-842 AC1200 Wave 2 MU-MIMO Wi-Fi Gigabit Router
User Manual
Creating Dynamic IPv6 or Static IPv6 WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 67. The page for creating a new Static IPv6 connection. The General Settings section.
Parameter
Interface
Connection name
Enable connection
Firewall
General Settings
A physical or virtual WAN interface to which the new connection
will be assigned.
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
If the switch is moved to the right, protection against external
connections for the LAN devices is enabled (for example, against
attempts to get information about the LAN devices or to hack a
device from the LAN). For security reasons, it is recommended not
to disable this function.
Page 80 of 210
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
