General Information; Installation Instructions - APW Wyott X TRM-2 Owner's Manual

NOTICE: Do not use toppings (butter, etc.) on product as product is inverted during
normal operation.
NOTICE: Operating toaster without legs invalidates any warranty claims.
NOTICE: Neglecting to keep fan opening clean could result in toaster failure.
XTRM-2 3":
1. Overall Dimensions w/Wire Feeder – 15.033"H (38.183cm) x 16.191"W (41.125cm) x 19.658"D (49.931cm)
2. Product Opening – 1.50"H (3.810cm) x 10.50"W (26.67cm)
3. Electrical Requirements (Single Phase):
A. 208V, 2840 Watt, 13.7 Amp.
B. 230/240V, 2840 Watt, 11.9 Amp.
C. Cordset configuration
1. Each toaster equipped with three wire grounded cordset and standard 3 prong plug.
4. Net/Shipping Weight – 49lb. (22.26kg)/46lb. (20.865kg)
XTRM-3 3":
1. Overall Dimensions w/Wire Feeder – 15.033"H (38.183cm) x 19.191"W (48.745cm) x 19.658"D (49.931cm)
2. Product Opening – 1.50"H (3.810cm) x 13.50"W (34.29cm)
3. Electrical Requirements (Single phase):
A. 208V, 3340 Watt, 14.0 Amp.
B. 230/240V, 3340 Watt, 14.0 Amp.
C. Cordset configuration
1. Each taster equipped with three wire grounded cordset and standard 2 prong plug.
4. Net/Shipping Weight – 50lb. (22.8kg)/47lb. (21.319kg)
1. Check Contents - refer to Figure 1, account for the following parts:
A. Remove foam pad and slide reflector tray in.
B. Ensure tray is properly engaged in the tray slides. To do this,
simply hold the front of the tray higher than the rear as the back
of the tray must slide under the slide on either side. You will
know if done correctly because tray will be secure. No rocking
or teetering will take place.
C. Toast Drawer - shipped in place
D. Instruction Manual - shipped loose
Warning: Operating toaster without reflector tray reduces toasting capabilities.

3 . GENERAL INFORMATION

4 . INSTALLATION INSTRUCTIONS

5