APW Wyott X TRM-2 Owner's Manual page 6

2. Toaster Placement
A. Locate toaster near a grounded receptacle of the proper configuration (see below). Plug the
cordset directly into receptacle (DO NOT USE AN EXTENSION CORD).
1. In the U.S.: 208, 230/240V uses NEMA 6-20R.
B. Place toaster on flat surface providing following minimum clearances:
1. Base = one inch (provided with legs installed).
2. Side and back walls = two inches
3. Overhead = Enough space to allow adequate heat displacement.
C. Position toaster where customers will not contact any surface labeled "CAUTION HOT".
Oven Stacking
The stacking kit will consist of 2 corner posts, with a metal frame, to be attached between stacked
units.
Warning: When stacking, unit must have proper stacking kit installed. This will
prevent overheating and damaging of electrical components.
Warning: Do not stack more than three units tall or do not use more than two
stacking kits.
Warning: Stand off on rear panel of unit is important to allow proper inlet and
exhaust fan airflow. Do not cover inlet or exhaust fan openings as this could damage
electrical components.
Refer to figures A-E
1. Ensure bottom unit is mounted on secure surface, with feet installed.
2. Remove respective corner end caps and screws. This will allow each of the stacking spacer
retaining fingers to slide into the extrusions.
3. Remove the feet from the top unit as shown.
4. Secure each stacking spacer to the bottom of the unit as shown by using the tapered guides that
lock into position.
5. Once the stacking kit spacers are secure, place top unit onto bottom unit. The stacking kit
spacers each have tapered guides to allow the unit to lock into position.
6. Refer to Cleaning Instructions for cleaning of stacking spacers and cleaning between units.
6