Ricoh TH-C1 Technical Bulletin page 34

Model:
Model TH-C1
6. While opening the rear development cover (A), push the shaft so that the shaft is
installed into the shaft holder hole.
Important: You cannot see the shaft holder hole (inside the cover). When the shaft
is installed correctly, you hear a click.
7. Make sure the shaft does not come out, by pulling out the shaft slowly and gently. If
the shaft comes out, repeat steps 5 and 6.
Important: If the shaft comes out completely, do not install the shaft again. In this
case, you have to replace the development unit.
8. Do steps 5 and 6 from "A: Procedure for adding the spacers to the toner supply
drive gear shaft - II. Main procedure".
Then do steps 1 to 7 from "A: Procedure for adding the spacers to the toner supply
drive gear shaft - III. Important points to check (1 to 8)".
T
echnical
A
B
ulletin
Date:
2-Jun-05
PAGE: 14/15
No.:
RB156003