Expansion Slots; S/Pdif Connector - DFI DL310-C226 User Manual

Expansion Slots

PCI Express x16
(x8 Signal)
PCI Express x1
PCI Express x16
(x8 Signal)
PCI Express x4
PCI Express x16 Slot
Install PCI Express x16 graphics card, that comply to the PCI Express specifications, into the
PCI Express x16 slot. To install a graphics card into the x16 slot, align the graphics card above
the slot then press it down firmly until it is completely seated in the slot. The retaining clip of
the slot will automatically hold the graphics card in place.
PCI Express x1 Slot
Install PCI Express cards such as network cards or other cards that comply to the PCI Express
specifications into the PCI Express x1 slot.
PCI Express x4 Slot
Install PCI Express cards such as network cards or other cards that comply to the PCI Express
specifications into the PCI Express x4 slot.
Chapter 2 Hardware Installation
Chapter 2

S/PDIF Connector

SPDIF out
Key Ground
S/PDIF
SPDIF in
+5V
1 5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
28
www.dfi .com