Before Installation; After Installation; Before Locating The Fixing Brackets; Adjusting The Bracket Position - Belling IHL773 User Manual

Before installation

• The work surface is square and level, and no structural members interfere with space requirements.
• The work surface is made of a heat-resistant material and insulated material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable standards and
regulations.
• A suitable isolating switch providing full disconnection from the mains power supply is incorporated
in the permanent wiring, mounted and positioned to comply with the local wiring rules and
regulations.
• The isolating switch must be of an approved type and provide a 3 mm air gap contact separation
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the
requirements).
• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
surrounding the hob.

After installation

• The power supply cable is not accessible through cupboard doors or drawers.
• If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
below the base of the hob.
• The isolating switch is easily accessible by the customer.

Before locating the fixing brackets

The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force to
the controls protruding from the hob.

Adjusting the bracket position

Once the hob has been placed into the worktop with the worktop seal, screw the installation brackets
to the underside of the hob. The installation brackets can be installed either way up depending on
the thickness of the worktop. There should be a small gap between the installation brackets and the
underside of the worktop to allow space for heat expansion.
HOB
TABLE
BRACKET
A
Under any circumstances,
the brackets cannot touch
the inner surfaces of the
worktop
(see picture).
25
after installation