User-Selectable Features; Programming Table For User-Selectable Features - Clifford concept 30 Owner's Manual

Remote controlled vehicle security and convenience system

Hide thumbs

Table Of Contents

Table of Contents

Your Concept 30 vehicle security system allows you to set many of its features to

your own personal preferences. We have made the programming procedures very

simple: to make a change, you just press the PlainView switch a few times.

The system comes from the factory with all of its features pre-programmed as noted in

the table below and on page 17. To change any of the settings, use the procedure

noted. To restore the feature to its factory setting, just repeat the procedure:

1. Select the feature you wish to program from the table below and on the following

page. Note the number of momentary (spring-loaded) presses.

2. Turn your vehicle's ignition switch to its "ON" position.

3. Enter your valet code.

4. When the LED turns on, immediately tap and release the momentary side of the

switch the number of times indicated in the third column of the programming

table for the feature you selected (after the first three taps, you will hear a single

chirp confirmation each time you tap the momentary side).

a. If noted, perform the "secondary action."

5. Return the switch to its center position. You will hear 1 chirp and the LED will

turn off. Turn the ignition off and you will hear 3 chirps to indicate that you have

exited programming mode.

6. Repeat steps 1-5 for any other features you wish to program.

Programming table for user-selectable features

# of

Factory

Feature

momentary

setting

taps

AutoArming

AutoArm

OFF

& Lock

Arm/Disarm

Chirp

Confirmation

QuietChirps

OFF

Valet Code

See How to set your own secret valet code on page 11.

AutoLock/

AutoUnLock