Delayed Courtesy Lights; Remote Control Operation; Programmable Features; Using Cliffnet Wizard Pro - Clifford Level Four Installation Manual

Prime level four security upgrade package

Hide thumbs

Table Of Contents

Table of Contents

Color profile: Disabled

Composite

Default screen

Delayed or dimming courtesy lights interfere with remote arming. If the delay is more than 5

seconds, turn on the Delayed Courtesy Lights feature noted on page 10.

REMOTE FUNCTIONS

Function

Arm & lock

Disarm & unlock

Trunk release

Panic

(repeated honks)

Locate

(short beep)

Remote valet mode

Option #2

Remote engine start

AutoStart/SafeStart

Window open/vent

The Level FOUR comes preprogrammed as noted in bold text in the following tables.

The CliffNet Wizard PRO software provides an intuitive access to all installer and end-user

features through a user-friendly, graphical user interface and provides extensive diagnostic

capabilities. See www.clifforddealer.com to download a free copy of the program (a #60-509

cable set is required to connect your Windows PC or palmtop to the G4 DataPort).

1. Note the column (across) and row (down) numbers of the feature(s) you wish to program.

2. Turn the ignition to the "ON" position or start the engine.

3. Enter the factory preset valet/programming code of "2" by toggling the valet switch

(located behind the LED assembly) to the left two times, then to the right (LED on).

4. Immediately hold to the left for about 3 seconds until you hear one horn beep and the

LED turns on to confirm the system is in the "Feature Select" position.

5. Select the feature column: Toggle the switch to the right the number of times indicated

for the column. Pause. You will hear the same number of horn beeps, confirming your

selection.

6. Within five seconds, select the feature row: Toggle the switch to the left the number of

times indicated for the row. You'll hear a beep each time to help you count.

7. If there is a NOTE for the selected feature, perform the actions noted.

8. Pause. You will hear either one or two beeps: two beeps = ON, one beep = OFF.

9. You can select another feature, or you can exit program mode:

a. To select another feature in that same column, repeat step 6 within the next five

seconds (after five seconds, three beeps indicate return to the "Feature Select" position).

b. To select a different feature column, repeat step 5.

c. To exit program mode, turn the ignition off (you'll hear three beeps and the LED will

turn off), or wait 60 seconds for the system to automatically exit program mode.

D:...-922 Level 4 install manual.vp

Wed Aug 04 17:37:19 1999