Device Paths Of Sparc M10-1 - Fujitsu M10 Product Notes

1. Stop an application to use an internal disk.
2. Remove the hardware RAID.
3. Identify whether the problem is related to the disk.
4. If the problem is not solved, replace all disks used for the hardware RAID.
5. Reconfigure the hardware RAID.
6. Restore data from a backup media.

Device Paths of SPARC M10-1

The following shows the device paths identified in SPARC M10-1.
Table 4-1
I/O device paths in a SPARC M10-1 cabinet and at the PCI expansion unit side
Device Device path
Internal SAS /pci@8000/pci@4/pci@0/pci@0/scsi@0
Internal HDD#0 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0
Internal HDD#1 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p1
Internal HDD#2 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p2
Internal HDD#3 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p3
Internal HDD#4 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p4
Internal HDD#5 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p5
Internal HDD#6 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p6
Internal HDD#7 /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p7
Internal LAN#0 /pci@8000/pci@4/pci@0/pci@1/network@0
Internal LAN#1 /pci@8000/pci@4/pci@0/pci@1/network@0,1
Internal LAN#2 /pci@8100/pci@4/pci@0/pci@0/network@0
Internal LAN#3 /pci@8100/pci@4/pci@0/pci@0/network@0,1
Internal USB port
rear: USB1.1 /pci@8000/pci@4/pci@0/pci@2/pci@0/usb@4/****@1
front: USB1.1 /pci@8000/pci@4/pci@0/pci@2/pci@0/usb@4/****@2
rear: USB2.0 /pci@8000/pci@4/pci@0/pci@2/pci@0/usb@4,1/****@1
front USB2.0 /pci@8000/pci@4/pci@0/pci@2/pci@0/usb@4,1/****@2
PCI#0 /pci@8000/pci@4/pci@0/pci@8/****@0
PCI#1 /pci@8100/pci@4/pci@0/pci@1/****@0
PCI#2 /pci@8100/pci@4/pci@0/pci@9/****@0
PCI expansion unit under PCI#0
Chapter 4 Information on SPARC M10-1 Hardware 53