When the CPU configuration at the initial
implementation is a four-CPU
The following shows the device paths when the CPU configuration at the initial
implementation is a four-CPU
Note - The following device paths are applied when the configuration is reduced from a
four-CPU to a two-CPU.
I/O devices in SPARC M10-4 cabinet
Table 5-3
I/O devices in SPARC M10-4 cabinet (at initial implementation: a four-CPU)
Device
LSB#0
Internal SAS
Internal HDD#0
Internal HDD#1
Internal HDD#2
Internal HDD#3
Internal HDD#4
Internal HDD#5
Internal HDD#6
Internal HDD#7
Internal LAN#0
Internal LAN#1
Internal LAN#2
Internal LAN#3
Internal USB port (rear: USB1.1)
Internal USB port (rear: USB2.0)
Internal USB port (front: USB1.1/2.0)
PCI#0
PCI#1
PCI#2
PCI#3
PCI#4
PCI#5
PCI#6
Device path
/pci@8000/pci@4/pci@0/pci@0/scsi@0
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p1
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p2
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p3
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p4
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p5
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p6
/pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p7
/pci@8000/pci@4/pci@0/pci@9/network@0
/pci@8000/pci@4/pci@0/pci@9/network@0,1
/pci@8400/pci@4/pci@0/pci@a/network@0
/pci@8400/pci@4/pci@0/pci@a/network@0,1
/pci@8000/pci@4/pci@0/pci@1/pci@0/usb@4/****@1
/pci@8000/pci@4/pci@0/pci@1/pci@0/usb@4,1/****@1
/pci@8000/pci@4/pci@0/pci@1/pci@0/usb@4,1/hub@2/****@1
/pci@8100/pci@4/pci@0/pci@0/****@0
/pci@8500/pci@4/pci@0/pci@8/****@0
/pci@8500/pci@4/pci@0/pci@9/****@0
/pci@8200/pci@4/pci@0/pci@0/****@0
/pci@8200/pci@4/pci@0/pci@8/****@0
/pci@8600/pci@4/pci@0/pci@9/****@0
/pci@8600/pci@4/pci@0/pci@11/****@0
Chapter 5 Information on SPARC M10-4 Hardware
61