Toro SprayMaster Max 34240 Operator's Manual page 34

Important:
The tank markings are for reference
only and cannot be considered accurate for
calibration.
1. Stop the machine on a level surface, move
motion control lever to the neutral position, stop
the engine, and set the parking brake.
2. Determine the amount of water needed to mix
the amount of chemical needed as prescribed
by the chemical manufacturer.
3. Open the tank cap on the spray tank.
4. Add 3/4 of the required water to the spray tank.
Important:
Always use fresh clean water in
the spray tank. Do not pour concentrate into
an empty tank.
5. Start the engine and place the throttle midway
between the SLOW and FAST positions.
6. Set the spray pump switch to the ON position.
1. Spray pressure control
knob
2. Left nozzle spray lever
On/Off
3. Center nozzle spray lever
On/Off
4. Right nozzle spray lever
On/Off
7. Move the throttle to the FAST position.
Note:
The water in the tank will circulate.
8. Before adding chemicals to the tanks, be sure:
•
the valving is set for the tank that is being
used; refer to
•
the spray pressure control knob is all the
way open (turn counterclockwise). This will
Figure 32
5. Spray wand spray lever
On/Off
6. Sprayer pressure gauge
7. Spray pump switch
Spray Pump Valving (page
increase circulation/agitation and help purge
the system of air.
9. Add the proper amount of chemical concentrate
to the tank, as directed by the chemical
manufacturer.
Important:
the powder with a small amount of water to
form a slurry before adding it to the tank.
10. Add the remaining water to the tank and secure
tank cap.
Note:
Anytime the tank has been run dry,
repeat steps
time required to purge the system of air.
Extending and Folding the Outer
Spray Booms
The outer spray booms can be rotated forward to
extend the boom or rearward to fold the boom.
g387122
1. Outer spray boom–folded
position
2. Rotate outward
Using the Sprayer Tank Shutoff
Valves
Selecting the Left Spray Tank
Rotate the valve handles to the positions shown in
Figure 34.
Important:
Always make sure at least one return
14).
valve is open when the spray pump is on.
34
If using a wettable powder, mix
5 through 10. This will reduce the
Figure 33
3. Outer spray
boom–extended position
g387133