Toro SprayMaster Max 34240 Operator's Manual page 24

4. To stop, position both motion control levers in
the neutral position; releasing the lever will
automatically return it to neutral.
Note:
Stopping distance may vary depending
on the spreader-sprayer load.
Driving in Reverse
1. Move the motion control lever to the neutral
position.
2. To move rearward in a straight line, slowly move
both levers rearward with equal pressure.
To turn left or right, release pressure on the
motion control lever toward the desired turn
direction.
3. To stop, position both motion control levers in
the neutral operate position.
Note:
Stopping distance may vary depending
on the spreader-sprayer load.
Adjusting the Front
Reference/Speed Control Bar
Adjust the front reference/speed control bar for
desired maximum forward speed.
1. Stop the machine and move the motion control
levers to the neutral position.
2. Loosen the knobs on both sides of the control
tower.
Figure 16
1. Motion-control levers
2. Adjustment knob
3. Move the bar forward to obtain the fastest speed.
Move the bar backward to obtain the slowest
speed.
g317115
4. On both sides, tighten the knobs.
Important:
Make sure the knobs are tight so the
front reference/speed control bar does not move
during operation.
Changing the Platform Suspension
The rubber isolators under the operator platform can
be adjusted to make the ride softer or harder. There
are three positions: front, middle, and rear.
To make the ride softer move the isolators to the front
position.
To make the ride stiffer move the isolators to the rear
position.
24
Figure 17
3. Front reference/Speed
control bar
g387111