Toro SprayMaster Max 34240 Operator's Manual page 15

Hopper Console
1. Spread pattern control
knob
2. Digital display gauge
3. Spread gate Open/Close
Spread Pattern Control Knob
Located on the left side of the hopper console and is
the fluted knob.
This control is used if the spread pattern is skewed or
dispensing too light/heavy to one side.
Rotate the knob counterclockwise if the pattern is
heavy to the right.
Rotate the knob clockwise if heavy to the left.
Spread Side Deflector Control
Located on the right side of the hopper console and
is the bottom knob.
Use the side deflector control to temporarily stop or
deflect granules away from sidewalks, parking lots,
patios, or anywhere granules are not desired to be
discharged from the left side of the spreader.
Push the knob down to lower the side deflector and
temporarily deflect the granules.
Pull the knob up to raise the side deflector.
Figure 9
4. Rate dial
5. Deflector control
g393058
1. Fence
2. Flowers
Rate Dial
Located on the hopper console to the right of the
digital display gauge (reference
The rate dial is used to set the amount of material to
be dispensed from the hopper gate.
With the Spread Open/Close handle in the closed
position, turn the dial to the appropriate setting. When
the Spread Open/Close is pulled to the open position,
the gate will open to the set position.
Note:
The slot, after setting 9 on the dial, allows the
hopper gate to be opened to the maximum position.
This setting can be used for dry sand, ice melt, or
other materials that are difficult to spread. It may
also be used for hopper cleanout; to
Spreader (page
Caster Wheel Lock Foot Pedal
Located on the right side of the operator platform (see
Figure 6).
Press and hold the caster wheel lock foot pedal to lock
the caster wheels in the straight position. Release
the foot pedal to unlock the caster wheels and allow
the machine to freely turn.
15
Figure 10
3. Side deflector lowered
Figure
Cleaning the
26).
g312556
9).