Toro SprayMaster Max 34240 Operator's Manual page 16

1. Caster pin locking mechanism
Drive Wheel Release Valves
WARNING
Hands may become entangled in the rotating
drive components below the engine deck,
which could result in serious injury or death.
Stop engine, remove key, allow all the moving
parts to stop before accessing the drive wheel
release valves.
WARNING
The engine and hydraulic drive units can
become very hot. Touching a hot engine or
hydraulic drive units can cause severe burns.
Allow the engine and hydraulic drive units to
cool completely before accessing the drive
wheel release valves.
Located on the inboard side towards the front of the
transaxle, which is in front of the Operator platform.
During normal operating conditions, the drive wheel
release valves are positioned horizontal in the Run
(operate) position.
If the machine has to be pushed by hand, the valves
must be in the Bypass (released) position.
Figure 11
g387110
1. Slot in Bypass (released)
position
To release the drive system (see item 1 in
rotate the slot a quarter-turn clockwise.
To reset the drive system (see item 2 in
rotate the slot a quarter-turn counterclockwise.
16
Figure 12
2. Slot in Run (operating)
position
Figure
Figure
g395205
12),
12),