Installing The Tpm Board And Cover - HP Synergy 480 Gen10 User Manual

Installing the TPM board and cover

Installing the TPM board and cover
Procedure Procedure
1. Observe the following alerts:
CAUTION: If the TPM is removed from the original compute module and powered up on a different compute module, CAUTION:
data stored in the TPM including keys will be erased.
CAUTION: The TPM is keyed to install only in the orientation shown. Any attempt to install the TPM in a different CAUTION:
orientation might result in damage to the TPM or system board.
2. Align the TPM board with the key on the connector, and then install the TPM board. To seat the board, press the TPM board firmly
into the connector. To locate the TPM connector on the system board, see the compute module label on the access panel.
3. Install the TPM cover:
a. Line up the tabs on the cover with the openings on either side of the TPM connector.
b. To snap the cover into place, firmly press straight down on the middle of the cover.
Installing the TPM board and cover 96