Table of Contents
Advertisement
12 | English
The blade/tines continues to rotate for a few seconds
u
after the machine is switched off.
Caution do not touch the rotating blade/tines.
u
Your product is double insulated for safety and requires no
earth connection. The operating voltage is 230 V AC, 50 Hz
(for non-EU countries 220 V, 240 V as applicable). Contact
your Bosch Service Centre for details. If in doubt contact a
qualified electrician or the nearest Bosch Service Centre.
For electrical safety use a Residual Current Device (RCD)
u
with a tripping current of not more than 30 mA. Always
check your RCD every time you use it.
Keep the supply cables away from moving hazardous parts
and avoid damage to the cables; this can lead to contact with
live parts.
The connections (plugs and sockets) should be kept dry and
off the ground.
The supply cables must be inspected for signs of damage at
regular intervals and may only be used if in perfect condi-
tion.
If the supply cable on the product is damaged, it must only
be replaced by a Bosch Service Centre. Only use approved
extension cables.
Use only extension cords, cables, leads and cable reels that
comply with EN 61242/IEC 61242 or IEC 60884-2-7 and
are of type H05VV-F or H05RN-F.
If you want to use an extension cable when operating your
product, only the following cable dimensions should be
used:
– Nominal conductor area of 1.25 mm
– Maximum length 30 m for a Cord Extension Set or max-
imum length of 60 m for a Cable Reel with Residual Cur-
rent Device (RCD).
Note: If an extension cable is used it must be earthed and
connected through the plug to the earth cable of your supply
network in accordance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest
Bosch Service Centre.
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and
socket must be of watertight construction
and intended for outdoor use.
For products not sold in GB:
WARNING: For your safety, it is required that the plug at-
tached to the product is connected with the extension cord.
The coupling of the extension cord must be protected
against splash water, be made of rubber or coated with rub-
ber. The extension cord must be used with a cable strain re-
lief.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
F 016 L94 458 | (13.07.2022)
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products that are only sold in AUS and NZ: Use a residual
current device (RCD) with a nominal residual current of 30
mA or less.
Maintenance
Always wear gardening gloves when handling or work-
u
ing near the sharp tines/blades.
Keep all nuts, bolts and screws tight to ensure safe work-
u
ing with the product.
Check the grass box frequently for wear or deterioration.
u
Inspect the product and replace worn or damaged parts
u
for safety.
Ensure replacement parts fitted are Bosch-approved.
u
Before storing, make sure that the product is clean and
u
free of residue. If necessary, clean with a soft dry brush.
Symbols
The following symbols are important for reading and under-
standing the original instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the product in a better and safer
manner.
Symbol
2
2
or 1.5 mm
Intended Use
The garden tool is intended for domestic lawn raking, vertic-
utting or aerating.
The garden tool is not intended for hedge cutting, trimming,
shredding, etc.
Meaning
Movement direction
Reaction direction
Wear protective gloves
Weight
Switching on
Switching off
Permitted action
Prohibited action
Audible noise
Accessories/Spare Parts
Bosch Power Tools
Advertisement
Table of Contents
