Advertisement
Operation Procedure
Use the wired or wireless remote for full up and down motion control. The non-momentary buttons
allow the user to press the buttons for both up and down control. Pressing any button while in motion
will stop the column.
Pairing the wireless remote
Press the UP and DOWN buttons on the wireless remote while simultaneously pressing the button
on the side of the control box for 10 seconds. The control box will emit a single beep to confirm the
pairing procedure has started. After 10 seconds, the wireless remote is now ready for use.
LED Light: A green light will indicate the column is in normal operation. A red light will indicate that
the column is locked. Please see the unlocking procedure below.
Reset Procedure
To reset the lifting column, press and hold the down button of the wired hand remote. After 10
seconds, the green light on the hand remote will start flashing. This indicates that the lifting column
is in reset mode. To complete the reset procedure, press and hold the down button for 10 seconds
until the green light stops flashing.
Safety Features
This column comes with a built-in self-locking features, when left idle for 10 seconds, the column will
lock and will be unresponsive to controls.
If the LED light is red, this will indicate you must unlock the column in order to lower the lift. Press
and hold the DOWN button for 5 seconds on either remote to unlock the lifting column for full control.
Ant-collision sensor: When retracting the lifting column, the control box will detect any obstructing
objects. Once detected, the column will stop and rise slightly.
Overcurrent Protection: While in motion, the controller will detect a current spike. When sensing a
current spike of 6.5A, the lifting column will stop to prevent any overloading errors.
Have any queries? Our expert engineers are here to help!
sales@progressiveautomations.com
1-800-676-6123
progressiveautomations.com
P a g e | 8
Advertisement
