Advertisement
Operation
Normal Operation
Using the wired remote, press and hold the 'Up' button to raise the lifting columns. To lower the lifting columns,
press and hold the 'Down' button. The 'Up' and 'Down' buttons are momentary controlled, when they are released,
the lifting columns will stop immediately.
To set a preset location, move the lifting columns to the desired height. Press the 'M' button followed by a
numbered button. The LED display will flash an 'S', followed by an 'S - Number'. This will indicate that the preset has
been saved.
To use a preset, press any of the numbered buttons and the lifting columns will begin to move to the preset
position. It is important to ensure that no obstacles impede the motion of travel. To stop the lifting columns, press
any button.
If the lifting columns do not function as intended or the LED display flashes "RSt", please follow the Reset
Procedure outlined in the next section.
Setting the LED Display
Using the wired remote, retract the lifting columns to the lowest position.
Press and hold the 'Down' button again until the LED display flashes "RST".
Press and hold the 'M' button until the LED display flashes the starting height (if the
display returns to "RSt" before the next step, repeat this step).
To change the value of the starting height, use the 'Up', 'Down' to increase and
decrease by 0.1. Use the '1', '2' to increase and decrease by 1s. Use the '3', and '4'
buttons to increase or decrease by 10s.
Once the correct value is displayed, wait 5 seconds until the LED display flashes
"RSt". Follow the Reset Procedure outlined in the next section to save the new
starting height.
Note: the LED display has a tolerance of ±0.1.
Reset Procedure
WARNING: During the Reset Procedure, the lifting columns will retract 7mm below the lowest normal operating
height, please ensure that no obstacles impede this motion of travel.
1. Move the lifting columns to the lowest position. (If there is an 'RSt' displayed on the remote,
continue to step 3.)
2. To initiate the Reset Procedure, press and hold the down button on the remote until "ASr" is
displayed. Release the down button.
3. Press and hold the down button on the remote, the lifting columns will begin to retract 7mm
lower than the lowest normal operating height. To stop motion at any time, let go of the down
button.
4. Once the lifting columns have completed the Reset Procedure, height will be displayed on the
remote.
5
Advertisement
