Operation/Safety - progressive automations FLT-11 User Manual

Operation Procedure
Use the wired or wireless remote for full up and down motion control. The non-momentary buttons
allow the user to press the buttons for both up and down control. Pressing any button while in
motion will stop the column.
Pairing the wireless remote
Press the UP and DOWN buttons on the wireless remote while simultaneously pressing the
button on the side of the control box for 10 seconds. The control box will emit a single beep to
confirm the pairing procedure has started. After 10 seconds, the wireless remote is now ready for
use.
LED Light: A green light will indicate the column is in normal operation. A red light will indicate
that the column is locked. Please see the unlocking procedure below.
Safety Features
This column comes with a built-in self-locking feature, where when left idle for 10 seconds, the
column will lock and will be unresponsive to controls.
If the LED light is red, this will indicate you must unlock the column in order to lower the lift. Press
and hold the DOWN button for 5 seconds on either remote to unlock the lifting column for full
control.
Anti-collision sensor: When retracting the lifting column, the control box will detect any
obstructing objects. Once detected, the column will stop and rise slightly.
Overcurrent Protection: While in motion, the controller will detect a current spike. When sensing
a current spike of 6.5A, the lifting column with stop to prevent any overloading errors.
6