Polishing; Working Procedures; Maintenance And Cleaning - Parkside PAAP 12 C3 Translation Of The Original Instructions

NOTE
► Make sure that a suitable sandpaper is
correctly fitted on the polishing disc
♦ Switch the appliance on.
♦ Guide the appliance across the workpiece
parallel to its surface.
♦ Move the unit parallel and evenly over the
surface to be sanded.
♦ Do not press the appliance down. Pressing
down hard does not improve the performance.
♦ When you are satisfied with the result, turn off
the appliance.

Polishing

♦ Add a little polish to the fitted polishing attach-
ment and the workpiece.
,
–
Polishing hood
–
Polishing hood
–
Fake fur attachment
polishing
♦ Manually spread the polish over the surface
you want to polish.
NOTE
► Do not apply the polish to the same surface
too often as the particles it contains could
damage the finish.
► Mask any plastic components beforehand as
these could be faded by the polish.
♦ Switch the appliance on.
♦ Guide the appliance across the workpiece
parallel to its surface.
♦ Move the appliance parallel and evenly over
the surface being polished.
♦ Do not press the appliance down. Pressing
down hard does not improve the performance.
♦ When you are satisfied with the result, turn off
the appliance.
■ 10 │ GB │ IE
.
(orange) for pre-polishing
(black) for final polishing
for high-gloss
ATTENTION!
► Depending on the size and nature of the
workpiece, suitable safety precautions must
be taken. Use suitable clamps to prevent the
workpiece from slipping.

Working procedures

■ Switch the appliance on before applying it to
the workpiece.
■ Apply minimal pressure when working.
■ Work at a constant speed.
■ Carry out the polishing process parallel to the
surface and overlap the polishing strokes.
■ After completing the task, lift the appliance from
the workpiece and then switch it off.

Maintenance and cleaning

WARNING!
► Always disconnect the battery pack
before carrying out any work on the appli-
ance.
The appliance is maintenance-free.
■ Always clean the appliance directly after
completion of work.
■ Use a dry cloth to clean the housing.
■ Remove any sanding dust stuck to the appliance
with a brush.
■ Never use sharp objects, petrol, solvents or
cleaning agents which can damage plastic. Do
not allow any liquids to get into the interior of
the appliance.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
PAAP 12 C3