Checking The Battery Charge Level; Assembly/Disassembly Of The Polishing Disc; Fitting The Attachments; Fitting The Additional Handle - Parkside PAAP 12 C3 Translation Of The Original Instructions

Checking the battery charge level

When the appliance is switched on, the remaining
charge is shown on the battery LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Assembly/disassembly
of the polishing disc
♦ Press the spindle lock
♦ Screw the polishing disc
screw thread .
♦ Proceed in the reverse order to remove the
polishing disc .

Fitting the attachments

ATTENTION!
► Be sure to remove the battery pack before
fitting or removing the attachments
, .
♦ The polishing disc
ments , , ,
sponding Velcro fasteners.
♦ To change them, lift the side of the attach-
ment , , ,
ing disc .
♦ First choose a sandpaper
press it onto the polishing disc
it is properly centred.
♦ Now select the polishing hood
for pre-polishing and push it onto the polishing
disc . Make sure it is properly centred.
♦ Now select the polishing hood
final polishing and press it onto the polishing
disc . Make sure it is properly centred.
♦ For the final finish, select the fake fur attach-
ment and press it onto the polishing
disc . Make sure it is properly centred.

Fitting the additional handle

♦ The additional handle
the left or right side of the appliance head,
depending on the mode of operation.
PAAP 12 C3
as follows:
and hold it down.
clockwise onto the
, ,
and supplied attach-
are fitted with corre-
and pull it off the polish-
for sanding and
. Make sure
(orange)
(black) for
can be screwed onto

Use

NOTE
► Always switch the hand grinder on before
applying it to the workpiece.
Switching the appliance on
♦ Press the safety lock-out
with the symbol to unlock the ON/OFF
switch .
♦ Press the ON/OFF switch
Switching the appliance off
♦ Release the ON/OFF switch
♦ Press the safety lock-out
with the symbol to lock the ON/OFF
switch .

2-speed gearbox

CAUTION!
► Operate the speed selector switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear
(speed selector switch
you can reach a speed of approx. 2800 rpm.
In second gear
(speed selector switch
you can reach a speed of approx. 8300 rpm.

Grinding

WARNING!
► Dust from materials such as paints, some
types of wood and metal can be harmful to
health.
► Contact with or inhalation of these dusts can
represent a health hazard for the person
operating the appliance and any other
people in the vicinity.
► Wear safety goggles and a protective dust
mask!
on the side
.
.
on the side
only
in position 1)
in position 2)
GB │ MT │ 57 ■