De Raat Sentry Manual

Sentry Safe manual
SFW082GTC
SFW123FTC
SFW205GPC
First time opening the safe
First you will need to install the batteries. To power the
lock, four alkaline AA batteries, equalling voltage 6Vdc (not
included) are required. Non-alkaline and rechargeable
batteries are not recommended.
To install batteries, turn the electric lock case to the right
and remove (figure H). Insert four new batteries as
indicated, replace the electric lock case and turn to the left
to reassemble.
For added security, some models (SFW082GTC and
SFW205GPC) have dual locking system (electronic lock plus
key lock). You must use both the electronic code and the
key to open the safe.
Now you will have to enter the electronic lock combination.
You will find this combination on the manual which is
supplied with the safe.
See below:
Only a light touch is needed. A green PROCEED light and
a single beep indicate that the keypad "felt" your touch.
The lock allows 5 seconds for each key press. If you
pause longer, an error signal will occur (blinking red light
and three beeps), indicating you should start over.
Safety reference: All codes are to be
securely stored. Do
(i.e. Birthdays, telephonenumbers, etc) as a
code.
Access codes
There are three possible ways to unlock and access the
safe—by entering its preset 5-digit electronic lock combi-
nation, your own user code or a user PIN (Personal Identi-
fication Number).
You can always open the safe by entering the 5-digit elec-
tronic lock combination. This code can not be deleted. But
if you prefer to employ your own code, you can program
the safe to open to the 5-digit user code of your choice. If
you wish to give someone else temporary access to the
safe, you can program a 5-digit user PIN that can later be
erased.

Programming a 5-digit user code

1. Press the Program key.
2. Enter the electronic lock combination. The green LED
remains on while you enter the 5-digit user code of
your choice. After 5 digits are entered the green LED
turns off.
To enter a new user code, repeat these steps.
To erase the user code, press the Program key and enter
your electronic lock combination twice.

Programming a 5-digit user PIN

Note: You must program a user code before programming
a user PIN.
1. Press the Program key.
2. Press it a second time.
3. Enter your 5-digit user code. The green LED remains on.
4. Enter the 5-digit user PIN of your choice (any combinati-
on except 00000). After 5 digits are entered the green
LED turns off.
To enter a new user PIN, repeat these steps.
To erase the user PIN, press the Program key twice, enter
your user code and then enter 00000.
NOT
use personal data