De Raat VP Safe Manual

VP Safe
Manual VP Safe
Opening the safe for the first time
Enter the user code.
The factory code is 0000.
The door will automatically
open.
Setting the user code
Important! The VP Safe comes pre-programmed with the 4-
digit user code "1234" so it is important this is changed as
soon as the safe is installed.
Only change the user code with the door open.
Enter the pre-programmed
current user code or use the
override key.
Press keys # and 1 at the same
time and the display will show
"CodeIn".
Now enter the new 4 digit code.
The display will then show
"repeat".
Re-enter the new 4 digit code.
The display will now show
"done" to confirm that the new
code has been accepted.
 
0 0 0 0
 
1
2 3
4
# 1
CodeIn
Note: If opening using the
override key, the key should be
kept in the open position (bolts
retracted) whilst the code is being
set.
?
? ?
?
If any digit is incorrectly
entered, it can be
cleared by pressing
#
Repeat
? ? ? ?
Done
Error
If the lock beeps and the
display shows "Ërror", all the
steps must be repeated.
Important! Please read the following instructions carefully
before installing your VP Safe. You will need to change the
code directly after installing the safe for your own safety. You
can write down your new code on the supplied code cart and
you can store this safely. You can only change the master code
with the current master code.
Setting the master code
Important! The VP Safe comes pre-programmed with the 4-
digit master code "0000" so it is important for security that this is
changed as soon as the safe is installed.
A record of the new code should be written down on the code
card provided and kept in a safe place.
The master code MUST be kept safe as it can only be changed
by first entering the current master code. If the current master
code is lost, it can not be changed.
Do not store the override key in the safe!
Enter the pre-programmed master
code.
With the safe unlocked, press keys
#, 3 and 9 at the same time. The
display will show "Ent Ad".
Enter the current 4 digit master
code. The pre-programmed code is
"0000".
The display will show "Ad rep".
Enter your new 4 digit master code. If any digit is incorrectly
The display will show "repeat".
Re-enter the new master code.
The display will now show "ad
set". Your code is now accepted.
Explanation
Signiture Explanation
Code is correct
Code is incorrect
Short sound signal
Long sound signal
Key on keypad
Key to lock door
Important information

0
0 0
0
# 3 9
Ent Ad
0 0 0
0
Ad rep
?
?
?
?
entered, it can be
cleared by pressing
#
Repeat
?
? ?
?
Ad set
Error
If the lock beeps and the
display shows "Ërror", all the
steps must be repeated.
